How To Configure a ZEBEX 3051 Scanner

This article outlines how a Zebex 3051 keyboard wedge scanner can be configured to operate with Fieldpine POS.

For keyboard wedge scanners to operate with Fieldpine POS, they are required to send special characters before and immediately after each barcode scan. The POS uses these additional characters to detect the difference between ordinary numbers being entered and a barcode scan.

You should have the manual "Single Line Handheld Scanner - User's Manual". Part Number MUL-53262-01

1. Turn to Page 12.
   1. Scan Start of Configuration
   2. Scan Reset to factory settings
   3. Scan End of Configuration

2. Turn to Page 23
   1. Scan Start of Configuration
   2. Scan Full ASCII code 39
   3. Scan End of Configuration

3. Turn to Page 35
   1. Scan Start of Configuration
   2. Scan Header premable
   3. On Page 36, Scan Full ASCII - STX
   4. On Page 35, Scan Save setting to confirm
   5. Scan End of Configuration

   6. Scan Start of Configuration
   7. Scan Trailer postamable
   8. On Page 36, Scan Full ASCII - ETX
   9. On Page 35, Scan Save setting to confirm
   10. Scan End of Configuration

4. Turn to Page 19
   1. Scan Start of Configuration
   2. Scan Message Terminator - None
   3. Scan End of Configuration

Once programmed, you should verify the operation using WordPad under Windows. If the scanner does not operate in Wordpad correctly it will not operate in the POS. To test in Wordpad, scan a product barcode, the barcode should repeat across the page:

     9400553060093940055306009394005530600939400553060093

THIS ARTICLE APPLIES TO

• POSGreen (all versions)